IBC HEATING SOLUTIONS

Holroyd HIBC container heaters are designed to heat products stored in 1000 Litre intermediate bulk containers. 

There are two types of heater available.

HIBC/A (Pictured left) is a silicone mat heater for placement below the container liner before filling. An insulation jacket covering four sides and the lid is also available to aid warm up time. Control is via a 0° C to 90° C Digital Thermostat housed in an enclosure along with a residual current device.

HIBC/B (Pictured right) is an insulated teflon coated polyester heater jacket, which covers all four sides of the container and has an optional insulated lid.

HIBC/A: -

Rating: 2700 Watts 230 Volts AC
Temp. Control: 20°C-90°C Electronic Controller (Digital Readout)
Performance: Water temp. from 15°C to 70°C in 42 hours (No Insulation Jacket)
Water temp. from 15°C to 70°C in 30 hours (With Insulation Jacket)

The HIBC/A silicone heater mat comprises of a high temperature resistance wire element laminated between silicone/ glass sheets.

A PTC temperature sensor is also embedded between the sheets. This connects to an electronic temperature controller via the heater power cable and provides accurate measurement and fast response to temperature changes at the bottom of the IBC liner. This makes the heater suitable for both high-energy absorbing products and highly viscous, temperature sensitive materials.

HIBC/B: -

Rating: 2 Circuits each 1000 Watts 110 or 240 Volts AC
Temp. Control: -5°C to +40°C or 20°C to 90°C Capillary Thermostat per Circuit
Performance: Water temp. from 15°C to 55°C in 56 hours (No Insulation Lid)
Water temp. from 15°C to 80°C in 56 hours (With Insulation Lid)

The HIBC/B insulated heater jacket has a heating element stitched into an insulated jacket made from a water-resistant, teflon coated poyester, insulated with a layer of filament insulation. This comes complete with release buckles for ease of installation and removal. The jacket has two separate heating circuits for its upper and lower halves; each circuit is controlled by an integral capillary thermostat.
 

All HIBC heaters are manufactured to conform to the EEC Low Voltage and EMC directives and CE marked accordingly.